Top MOSFET,INTEGRATED CIRCUITS,INTEGRATED CIRCUIT Products in Mumbai at best prices

STMPS2141STR SOT-23-5, STMicroelectronics

The STMPS2141, STMPS2151, STMPS2161, STMPS2171 power distribution switches are intended for applications where heavy capacitive loads and short-circuits are likely to be encountered. These devices incorporate 90 mW N-channel MOSFET high-side power switches for power distribution. These switches are controlled by a logic enable input. When the output load exceeds the current limit threshold or a short is present, the device limits the output current to a safe level by switching into a constant current mode. When continuous heavy overloads and short-circuits increase the power dissipation in the switch, causing the junction temperature to rise, a thermal protection circuit shuts the switch off to prevent damage. Recovery from a thermal shutdown is automatic once the device has cooled sufficiently. Internal circuitry ensures the switch remains off until a valid input voltage is present.

INTEGRATED CIRCUITS

L78M12CDT-TR IC REG LINEAR 12V 500MA DPAK

The L78M series of three-terminal positive regulators is available in TO-220, TO-220FP, DPAK and IPAK packages and with several fixed output voltages, making it useful in a wide range of applications. These regulators can provide local on-card regulation, eliminating the distribution problems associated with single point regulation. Each type employs internal current limiting, thermal shutdown and safe area protection, resulting it essentially indestructible. If adequate heat sinking is provided, they can deliver over 0.5 A output current. Although designed primarily as fixed voltage regulators, these devices can be used with external components to obtain adjustable voltage and currents

INTEGRATED CIRCUITS

LC6516AB RichMicro

The LC6516AB is a high-performance primary-side controller (PWM) produced by RichMicro, specifically designed for low-power offline battery charger applications.

OPERATIONAL AMPLIFIERS

LM2904DT STMicroelectronics SOIC-8 SMD/SMT

INR 3

MCU

STM32G070CBT6 STMicroelectronics IC MCU 32BIT 128KB FLASH 48LQFP

INR 58

Traics

BT137-600E TRIAC TO-220M WXDH ELECTRONICS

INR 6.1

MCU

STM32G070CBT6, STMicroelectronics, IC MCU 32BIT 128KB FLASH 48LQFP

ARM® Cortex®-M0+ STM32G0 Microcontroller IC 32-Bit 64MHz 128KB (128K x 8) FLASH 48-LQFP (7x7) The STM32G070CBT6 is a 32-bit ARM® Cortex®-M0+ microcontroller from STMicroelectronics, designed for high-efficiency performance in embedded and industrial control applications. Operating up to 64 MHz, it features 128 KB Flash memory, 36 KB SRAM, and a rich set of peripherals including ADCs, DACs, timers, USARTs, I²C, and SPI interfaces. This MCU offers low power consumption and robust security features, making it ideal for applications such as consumer electronics, motor control, power management, IoT devices, and communication equipment. End Use: Industrial automation, consumer electronics, motor control units, IoT gateways, and power systems. Features • Includes ST state-of-the-art patented technology • Core: Arm® 32-bit Cortex®-M0+ CPU, frequency up to 64 MHz • -40°C to 85°C operating temperature • Memories – 128 Kbytes of flash memory with protection – 36 Kbytes of SRAM (32 Kbytes with HW parity check) • CRC calculation unit • Reset and power management – Voltage range: 2.0 V to 3.6 V – Power-on/Power-down reset (POR/PDR) – Low-power modes: Sleep, Stop, Standby – VBAT supply for RTC and backup registers • Clock management – 4 to 48 MHz crystal oscillator – 32 kHz crystal oscillator with calibration – Internal 16 MHz RC with PLL option – Internal 32 kHz RC oscillator (±5 %) • Up to 59 fast I/Os – All mappable on external interrupt vectors – Multiple 5 V-tolerant I/Os • 7-channel DMA controller with flexible mapping • 12-bit, 0.4 µs ADC (up to 16 ext. channels) – Up to 16-bit with hardware oversampling – Conversion range: 0 to 3.6V • 11 timers: 16-bit for advanced motor control, five 16-bit general-purpose, two basic 16-bit, two watchdogs, SysTick timer • Calendar RTC with alarm and periodic wakeup from Stop/Standby • Communication interfaces – Two I2C-bus interfaces supporting Fastmode Plus (1 Mbit/s) with extra current sink, one supporting SMBus/PMBus and wakeup from Stop mode – Four USARTs with master/slave synchronous SPI; two supporting ISO7816 interface, LIN, IrDA capability, auto baud rate detection and wakeup feature – Two SPIs (32 Mbit/s) with 4- to 16-bit programmable bitframe, one multiplexed with I2S interface; four extra SPIs through USARTs • Development support: serial wire debug (SWD) • All packages ECOPACK 2 compliant

OPERATIONAL AMPLIFIERS

LM2904DT STM

This circuit consists of two independent, high gain, internally frequency compensated operational amplifiers which were designed specifically for automotive and industrial control system. It operates from a single power supply over a wide range of voltages. The low power supply drain is independent of the magnitude of the power supply voltage. Application areas include transducer amplifiers, DC gain blocks and all the conventional op-amp circuits which now can be more easily implemented in single power supply systems. For example, these circuits can be directly supplied from the standard +5 V which is used in logic systems and will easily provide the required interface electronics without requiring any additional power supply. In the linear mode the input common-mode voltage range includes ground and the output voltage can also swing to ground, even though operated from a single power supply

MOSFET

MT7606EH MAXIC, 500V, SOT89-3,TO252-3,ESOP8

MT7606 is a high current precision linear LED driver. The output constant current is programmable by an external resistor. MT7606 integrates high voltage power MOSFET and high voltage power supply circuit, the peripheral circuit is simplified. It can easily pass EMI without inductor, transformer or other magnetic components, low BOM cost isachieved. The good line regulation keeps input power constant. The chip integrates thermal regulation function to balance the output power and system temperature. The output current will be reduced while the junction temperature goes higher than the threshold, system reliability is guaranteed

TRANSISTOR

STP75NF75, STM MICROELECTRONICS, MOSFET N-CH 75V 80A TO220AB

This Power MOSFET series realized with STMicroelectronics unique STripFET™ process has specifically been designed to minimize input capacitance and gate charge. It is therefore suitable as primary switch in advanced highefficiency, high-frequency isolated DC-DC converters for Telecom and Computer applications. It is also intended for any applications with low gate drive requirements.

MOSFET

STW48N60M2 MOSFET N-CH 600V 42A TO247-4L

INR 84

INTEGRATED CIRCUITS

MMPF0100F0AEP, NXP Semiconductors, QFN-56

INR 250

INTEGRATED CIRCUITS

DB201BDJ, VISHAY, 22V 20A, 16 TSSOP

INR 43

MOSFET

NCE3008Y, WUXI NCE POWER CO,LTD, SOT23-3L, 30 V, 8 A

INR 3

MOSFET

SD6835, Silan Microelectronics, 650V 7A, DIP‑8

INR 13

MOSFET

CSD18534Q5AT, Texas Instruments, VSONP-8, 60V 100A

MOSFETs 60V N-Ch NexFET Pwr MOSFET A 595-CSD18534Q5AT This 7.8 mΩ, 60 V, SON 5 × 6 mm NexFET™ power MOSFET is designed to minimize losses in power conversion applications.